Hyundai Elantra: Power Door Locks / Power Door Lock Module Repair procedures

Inspection
   
Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
Disconnect the connector from the actuator.

No
Pin Information
LH
RH
1
-
-
2
Lock / Unlock switch
Motor 2
3
COM
Motor 3
4
Key Lock switch
Key Unlock switch
5
Key Unlock switch
Key Lock switch
6
Motor 3
COM
7
Motor 2
Lock / Unlock switch
8
-
-

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Module Inspection
1.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
2.
Remove the rear door module.
(Refer to Body - "Rear Door Module")
3.
Disconnect the connectors from the actuator.

No
Pin information
LH
RH
1
-
-
2
Lock / Unlock switch
Motor 2
3
COM
Motor 3
4
-
-
5
-
-
6
Motor 3
COM
7
Motor 2
Lock / Unlock switch
8
-
-

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Trunk Lock Module Inspection
1.
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
2.
Disconnect the connector from the actuator

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

4.
Checking the trunk of the vehicle power option power refers to the trunk module.
Power Door Lock Module Components and Components Location
Conponents 1. Door lock/unlock knob cable2. Door inside handle cable3. Door Latch ...

Power Door Lock Switch Repair procedures
Inspection Power Door Lock Switch Inspection 1. Check for continuity between the terminals. If there is an abnormality, replace the switch. Removal     • Be careful not ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Owners Manual: Interior Lights
WARNING Do not use the interior lights when driving in the dark. The interior lights may obscure your view and cause an accident. NOTICE Do not use the interior lights for extended periods when the engine is turned off or the battery will discharge. Interior lamp AUTO cut The interior lamps ...

© 2018-2025 www.helantraad.com