Hyundai Elantra: Front Door / Front Door Belt Outside Weatherstrip Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Outside Weatherstrip Repair procedures

Replacement

1.	Pull down the front door window glass to the lowest level by pressing the power window glass switch.

After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

Tightening torque :

1.0 ~ 2.0 N.m (0.1 ~ 0.2 kgf.m, 0.7 ~ 1.4 lb-ft)

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Front Door Outside Handle Repair procedures

Replacement 1. Remove the plug hole (B). 2. After loosening the mounting bolt, remove the front door lock assembly (A). Tightening torque : 7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft ...

Front Door Belt Inside Weatherstrip Repair procedures

Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. To intall, reverse the removal procedure. ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Smart Cruise Control Switch
CRUISE: Turns cruise control system on or off. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. : Sets vehicle-to-vehicle distance. CANCEL: Cancels cruise control operation. ...

Hyundai Elantra AD (2016-2020) Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. ...