Hyundai Elantra: Power Door Locks / Power Door Lock Switch Repair procedures

Inspection
Power Door Lock Switch Inspection
1.
Check for continuity between the terminals. If there is an abnormality, replace the switch.

Removal
   
Be careful not to scratch the door trim and other parts.
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
Driver Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the power window switch assembly after disengaging the mounting clips.

Installation
1.
Install the power window switch assembly.
2.
Install the front door trim after connect the connector.
3.
Connect the negative (-) battery terminal.
Power Door Lock Module Repair procedures
Inspection     • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/asse ...

Power Door Mirrors
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: General Information
General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight connections. (Refer to Engine Electrical System - "Battery")     • Do not qu ...

Hyundai Elantra AD (2016-2020) Service Manual: TPMS Receiver Description and Operation
Description TPMS Receiver : BCM(body control module) integrated management 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no Auto-Location, no sensor wake-up, no sens ...

© 2018-2025 www.helantraad.com