Hyundai Elantra: IMS(Integrated Memory System) / Memory power seat switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the memory power seat switch connector (A).

4.
Remove the memory power switch (A) after disengaging the mounting clips.

Installation
1.
Install the memory power seat control switch (IMS).
2.
Install the door trim.
3.
Connect the negative (-) battery terminal.
Inspection
1.
Remove the memory power seat connector

2.
When each switch is pressed, check the electricity flow between memory power seat switch connector and grounding, and if the electricity does not match the specification, replace the switch.

Memory power seat switch Components and Components Location
Components ...

Seat Electrical
...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: ESC OFF usage
When Driving The ESC OFF mode should only be used briefly to help free the vehicle if stuck in snow or mud by temporarily stopping operation of the ESC to maintain wheel torque. To turn ESC off while driving, press the ESC OFF button while driving on a flat road surface. NOTICE To prevent da ...

Hyundai Elantra AD (2016-2020) Service Manual: BJ Boot Components and Components Location
components (1) 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ housing13. Clip components (2) 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Shaft6. TJ boot ban ...

© 2018-2025 www.helantraad.com