Hyundai Elantra: Hood / Hood Latch Release Handle Components and Components Location

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Components and Components Location

Component Location

1. Hood latch release handle


Hood Weatherstrip Repair procedures
Replacement 1. Remove the hood weatherstrip (A).     • Be careful not to scratch the hood weatherstrip. 2. To intall, reverse the removal procedure. ...

Hood Latch Release Handle Repair procedures
Replacement 1. Using a socket (B), remove the hood release handle (A). 2. To intall, reverse the removal procedure.     • Make sure the hood latch cable is connected pr ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Description and Operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by ...

Hyundai Elantra AD (2016-2020) Owners Manual: Floor Mat Anchor(s)
ALWAYS use the Floor Mat Anchors to attach the front floor mats to the vehicle. The anchors on the front floor carpet keep the floor mats from sliding forward. WARNING The following must be observed when installing ANY floor mat to the vehicle. Ensure to remove a protective film attached o ...

© 2018-2025 www.helantraad.com