Hyundai Elantra: Hood / Hood Insulator Pad Repair procedures

Replacement
1.
Using a clip remover, remove the clips and then the hood insulator pad (A).
   
Be careful not to scratch the hood panel.

2.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Hood Assembly Repair procedures
Replacement     • Be careful not to damage the hood and body.     • Removing or installing the hood requires an assistant. • When removing ...

Hood Weatherstrip Repair procedures
Replacement 1. Remove the hood weatherstrip (A).     • Be careful not to scratch the hood weatherstrip. 2. To intall, reverse the removal procedure. ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.54.5W.O.T4.410.59 ETC Motor 1. Turn the ignition ...

Hyundai Elantra AD (2016-2020) Service Manual: Timing Chain Repair procedures
Removal 1. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") 2. Set No.1 cylinder to TDC (Top dead center) on compression stroke. (1) Turn the crankshaft pulley and align its groove with the timing mark of the timing chain cover. (2) Check that ...

© 2018-2023 www.helantraad.com