Hyundai Elantra: Engine And Transaxle Assembly / Engine Room Under Cover Repair procedures

Removal and Installation
Engine Room Under Cover
1.
Remove the engine room under cover (A).

Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

2.
Install in the reverse order of removal.
Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A).     • To avoid damage, remove the engine cover on room temperature. • To avoid damage of the engine cover, ...

Engine Mounting Components and Components Location
Components 1. Transaxle mounting bracket2. Roll rod bracket3. Engine mounting bracket4. Engine mounting support bracket ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Impact Sensor (FIS) Description and Operation
Description • The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at their mounting locations. • The primary purpose of the Front Impact Sensor (FIS) is to pro ...

Hyundai Elantra AD (2016-2020) Owners Manual: Driving in Flooded Areas, Highway Driving
Driving in Flooded Areas Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake performance may be reduced. After driving through water, dry the brakes by ge ...

© 2018-2026 www.helantraad.com