Hyundai Elantra: Hood / Hood Assembly Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement

•	Be careful not to damage the hood and body.

•	Removing or installing the hood requires an assistant.

•	When removing the clips, use a clip remover.

After loosening the hood hinge (A) mounting bolts, remove the hood assembly (B).

Tightening torque :

21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

To intall, reverse the removal procedure.

•	Make sure the hood locks / unlocks and opens / closes properly.

•	Adjust the hood alignment.

Hood Assembly Components and Components Location

Component Location 1. Hood assembly ...

Hood Insulator Pad Repair procedures

Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A). • Be careful not to scratch the hood panel. 2. To intall, reverse th ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification : Refer to "Wave Form" Removal • DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine ...

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Tank Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly") 3. Remove the fuel pump service cover (A). 4. Disconnect the fuel pump connect ...