Hyundai Elantra: Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification : Refer to "Specification"

Intake Air Temperature Sensor (IATS) Schematic Diagrams
Circuit Diagram ...

Engine Coolant Temperature Sensor (ECTS) Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor whose ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: SS-A Solenoid Valve(ON/OFF) Specifications
Specifications ? Control type : Normally low type ShapeItems Specifications Control current(voltage) [V] 9 ~ 16 Supply pressure [kpa (kgf/cm?, psi)] 490.33 (5.0, 71.12) Control pressure [kpa (kgf/cm?, psi)] 0 ~ 490.33 (0 ~ 5.0, 0 ~ 71.12)  Internal resistance(?) 10 ~ ...

Hyundai Elantra AD (2016-2020) Service Manual: Shift Lever Repair procedures
Removal 1. Pull the knob (A) in the direction of "F" and remove the knob. 2. Disconnect the connector (B) from the shift lever. 3. Disconnect the fixing clip (A) of wiring. 4. Disconnect the shift cable. (1) Remove the snap pin (A). (2) Disconnect the cable eye end (B) from t ...

© 2018-2022 www.helantraad.com