Hyundai Elantra: Heating, Ventilation and Air Conditioning / Controller
- Heater & A/C Control Unit (Manual) Components and Components Location
- Heater & A/C Control Unit (Manual) Repair procedures
- Heater & A/C Control Unit (DATC) Components and Components Location
- Heater & A/C Control Unit (DATC) Repair procedures
Intake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...
Heater & A/C Control Unit (Manual) Components and Components Location
Components
ConnectorPin NOFunctionConnectorPin NOFunctionA1LowB18ILL- (RHEO)2Common19Sensor ground3Ground20Ground4Middle Low21Battery (+)5Middle High22ISG DC6High23ISG B+B1IGN224ILL+ (TAIL)2PAB I ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Auto Defogging Sensor Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Combination Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the outside rear combination lamp assembly (B) after disconnecting the connector (A).
3.
Remove the bulb (A) after turning it in the counter clock-wise direction.
[LED Type]
[Bulb Type]
4.
Disconnect the inside rear ...
