Hyundai Elantra: Controller / Heater & A/C Control Unit (Manual) Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box upper cover assembly.
(Refer to Body - "Glove Box Upper Cover Assembly") |
| 3. |
Loosen the mounting screws and remove the crash pad center lower cover [LH](A).
|
| 4. |
After loosening the mounting screws, remove the A/C & heater controller unit (A).
|
| 5. |
Disconnect the A/C & heater controller connectors (A) and hose (B).
|
| 6. |
To intall, reverse the removal procedure.
|
Heater & A/C Control Unit (Manual) Components and Components Location
Components
ConnectorPin NOFunctionConnectorPin NOFunctionA1LowB18ILL- (RHEO)2Common19Sensor ground3Ground20Ground4Middle Low21Battery (+)5Middle High22ISG DC6High23ISG B+B1IGN224ILL+ (TAIL)2PAB I ...
Heater & A/C Control Unit (DATC) Components and Components Location
Components
ConnectorPin NOFunctionConnectorPin NOFunctionA1Battery (+)A21IGN12IGN222ILL+ (TAIL)3ISG B+23Sensor ground REF (+5V)4Mode control actuator (Vent)24C_CAN High5Mode control actuator (Def ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: PTC Heater Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation by confirmation logic as follows.
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2)
Turn off the blower switch.
(3)
Press the intake (recirculation) button 5 times or more.
(4)
\Indicators ...
Hyundai Elantra AD (2016-2020) Owners Manual: Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However,
if you notice unusual tire wear or your vehicle pulling one way or the other ...
