Hyundai Elantra: Blind Spot Detection System / Blind Spot Detection Switch Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
| 3. |
Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.
|
| 4. |
Remove the rheostat switch connector (A).
|
| 5. |
Check for intensity of new rheostat switch. If the light
intensity of the lamps changes smoothly without any flickering when the
rheostat is turned, it can be assumed that the rheostat is normal.
|
Blind Spot Detection Switch Components and Components Location
Circuit Diagram
...
Blind Spot Detection Indicator Components and Components Location
Components
1. BSD Indicator2. Side repeater lamp
...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Forward Collision Avoidance Assist Warning Light, Lane Keeping Assist (LKA)
System Indicator Light
Forward Collision Avoidance Assist Warning Light (if equipped)
This warning light illuminates :
When you set the ignition switch or Engine Start/Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When there is a malfunction with FCA. In this ca ...
Hyundai Elantra AD (2016-2020) Owners Manual: Key ignition switch positions
LOCK
To turn the ignition switch to the LOCK position, put the key in at the ACC position
and turn the key towards the LOCK position. The ignition key can be removed in the
LOCK position. (The shift lever must be in the P (Park) position for Intelligent
Variable Transmission (IVT)/dual clutch ...
