Hyundai Elantra: Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Mechanical System / Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Removal and Installation

1.	Disconnect the vacuum hose (A).

Remove the variable Intake solenoid (VIS) actuator connector (B) and actuator (C).

Tightening torque :

9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

3.	Install in the reverse order of removal.

Intake Manifold Repair procedures

Removal and Installation 1. Remove the engine cover. (Refer to Engine And Transaxle Assembly - “Engine Cover”) 2. Disconnect the battery negative terminal. 3. Remove the air duct an ...

Exhaust Manifold Components and Components Location

Components 1. Heat protector2. Exhaust manifold gasket3. Exhaust manifold4. Exhaust manifold stay ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Head Lamps Components and Components Location
Components [Standard] 1. Head lamp (Low)2. Head lamp (High)3. Turn signal lamp4. Dust cap5. Position lamp6. Side marker [HID] 1. Head lamp (Low - HID)2. Head lamp (High)3. Turn signal lamp4. Dust cap5. Side marker ...

Hyundai Elantra AD (2016-2020) Service Manual: Refrigerant Line Repair procedures
Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Recover the refrigerant with a recovery / charging station. ...