Hyundai Elantra: Ignition Switch Assembly / Repair procedures
Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad") |
| 3. |
Remove the steering column upper & Lower shroud. |
| 4. |
Remove the ignition switch (A) and disconnecting the Key Warning / immobilizer connector.
|
| 5. |
If it is necessary to remove the key lock cylinder (A),
remove the key lock cylinder (A) after pushing lock pin (B) with key
ACC.
|
| 6. |
Installation is the reverse of removal procedure. |
| Inspection |
| 1. |
Disconnect the ignition switch connector (A) and key warning switch connector (B) from under the steering column.
|
| 2. |
Check for continuity between the terminals. |
| 3. |
If continuity is not specified, replace the switch.
|
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Module Components and Components Location
Component Location
1. Rear door module
...
Hyundai Elantra AD (2016-2020) Owners Manual: Drive Info display
This display shows the trip distance (1), the average fuel economy (2), and the
total driving time (3).
The information is combined for each ignition cycle. However, when the engine
has been OFF for 4 hours or longer the Drive Info screen will reset.
To reset the details, press and hold the ...
© 2018-2025 www.helantraad.com
