Hyundai Elantra: Indicators And Gauges / Troubleshooting

Troubleshooting
Error Item
Failure symptom
Inspection items
Detailed inspections
Relevant Parts/
Components
Screen display
TFT-LCD screen does not turn on
1.
Connector attachments
2.
Components
1.
Check the connector attachments
2.
Check B+, IGN and GND wiring
3.
Check the components
Connectors, wiring, fuses, dashboard
Warning light
Airbag warning lamp malfunction
1.
Connector attachments
2.
C-CAN
3.
Components
1.
Check airbag + signal (connectors)
2.
Check C-CAN (ACU4) signal
3.
Check the FPC attachment inside the dashboard
ACU Connectors, wiring, fuses, dashboard
Mode conversion
Integrated driving mode malfunction
1.
Connector attachments
2.
Switch
3.
Components
1.
Check the switch input (connector)
2.
Check the switch signal input
(disconnection or shorting)
3.
Check conversion with dashboard component
Switch connector, wiring dashboard
Illumination
Interior light brightness cannot be controlled.
1.
Connector attachments
2.
Switch
3.
Components
1.
Check if the light switch's input signal reaches the connector
2.
Check ILL- and DETENT signals
3.
Check the TAIL+ signal input
Switch connector, wiring dashboard
Warning Sound
No dashboard alarm
1.
Connector attachments
2.
Car speakers
3.
Components
1.
Check the speaker output connector
2.
Check the car speakers
Speaker connectors, wiring dashboard
Fuel indicator
Faulty fuel gauge indication
1.
Connector attachments
2.
Fuel sender
3.
Components
1.
Check fuel input and GND connectors
(open, short or input resistance values)
2.
Check fuel sender
Fuel sender connector, wiring dashboard

Instrument Cluster Repair procedures
Removal     • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the re ...

Power Door Locks
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Description and Operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Inspection ABS System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid.     • If the ...

© 2018-2021 www.helantraad.com