Hyundai Elantra: Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation

Description
•
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body.
•
This variable force solenoid valve indirectly controls the hydraulic pressure inside the torque converter.

Output Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications ? Control type : Normally low type ShapeItems Specifications Control current(voltage) [mA] 0 ~ 850 Supply pressure [kpa (kgf/cm?, psi)] 539.36 (5.5, 78.23) Control ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Body Side Molding
Delta Garnish Repair procedures Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Diagnosis with GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. 3. Sele ...

© 2018-2026 www.helantraad.com