Hyundai Elantra: Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
2.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

3.
Loosen the mounting screws and remove the crash pad lower panel (A).

4.
Disconnect the diagnosis connector (A) and airbag connector (B).

5.
To intall, reverse the removal procedure.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips (or pin-type retainers).
Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Steering Column Shroud Panel Components and Components Location
Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Seat Heater Switch Repair procedures
Removal [Front Seat] 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly") [Rear Seat] 1. Disconnect the negative (-) battery terminal. 2. Remove the rear door window switch. (Refer to Power Windows - "Po ...

Hyundai Elantra AD (2016-2020) Owners Manual: Manual Climate Control System
To defog inside windshield 1. Select any fan speed except “0� position. 2. Select desired temperature. 3. Select the or position. 4. The outside (fresh) air will be selected automatically. Additionally, the air conditioning will automatically operate if the mode is selected to the p ...

© 2018-2026 www.helantraad.com