Hyundai Elantra: Button Engine Start System / Start/Stop Button Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash ped lower panel.
(Refer to Body - "Crash Ped Lower Panel")
3.
Remove the start/stop button (B) after disconnect the connector (A).

Installation
1.
Install the start/stop button.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.
Start/Stop Button Components and Components Location
Component ...

LKAS(Lane Keeping Assist System)
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Stabilizer Bar Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to dam ...

Hyundai Elantra AD (2016-2020) Service Manual: Side Impact Sensor (SIS) Description and Operation
Description • Side Impact Sensors (SIS), each installed on the center part of the right and left front door modules and the right and left center pillars, detects side impact during collision. • The SRSCM uses the signals from SIS during side collision to determine whether and w ...

© 2018-2026 www.helantraad.com