Hyundai Elantra: Blind Spot Detection System / Blind Spot Detection Unit Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper. (Refer to Body - "Rear Bumper")

Remove the BSD unit (A) after loosening the mounting nuts.

•	Take care not to separate the bracket from rear bumper when removing the BSD sensor.

Installation

1.	Install the BSD units to the rear bumper.

2.	Install the rear bumper.

Connect the negative (-) battery terminal.

•	Take care not to confuse left side (master) and right side (slave) unit when installing.

•	BSD units connector connect to the wiring connector.

Blind Spot Detection Unit Schematic Diagrams

Circuit Diagram ...

Blind Spot Detection Switch Components and Components Location

Circuit Diagram ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification : Refer to "Specification" Removal 1. Turn the ignition switch O ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lide trim. (Refer to Body - "Trunk Lid Trim") 3. Disconnect the back view camera connector. 4. Remove the back view camera (A) after loosening the moungting screws. Installation 1. Install the back vie ...