Hyundai Elantra: Body Side Molding / Roof Side Molding Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Using a screwdriver or remover, remove the roof side molding (A).

•	Always replace the roof side molding to a new one.

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Mud Guard Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Sunroof

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rear Body Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer panel rear cornerSide outer panel rear cornerSide outer panel rear cornerRear combination lamp mounting hole (O8)Rear bumper mounting hole (8.5X8.5)Rear bumper mounting hole (14X16 ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Remove the high pitch horn and low pitch horn after disconnect the horn connector (A) and loosening the mounting the bolt. [Low Pitch Horn] [High Pitch Horn] Installation 1. Install the horns after ...