Hyundai Elantra: Body Side Molding / Rear Mud Guard Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Mud Guard Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	After loosening the mounting screws and remove the rear mud guard (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Front Mud Guard Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Roof Side Molding Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Disc Brake Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub . Tightening torque: 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • Be careful not to da ...

Hyundai Elantra AD (2016-2020) Service Manual: Evaporator Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3. Remove the heater unit lower case (A) after loosening the mounting screws. 4. Pull out the evaporator core (A) from the heater unit. 5. T ...