Hyundai Elantra: Driver Position Memory System / Resetting the Driver's Seat Memory System

Take the following procedures to reset the driver's seat memory system, when it does not operate properly.

To reset the driver's seat memory system

1. Set the ignition switch to the ON position, set the gear in P (Park), and open the driver's door.

2. Operate the control switch to set the driver's seat and seatback to the foremost position.

3. Simultaneously press the SET button and push forward the seat movement switch over 2 seconds.

While resetting the driver's seat memory system

1. It starts with the notification sound.

2. The driver's seat and seatback is adjusted to the rearward position with the notification sound.

3. The driver's seat and seatback is re-adjusted to the default position (central position) with the notification sound.

However, in the following cases, the resetting procedure and the notification sound may stop.

- The memory button is pressed.
- The control switch is operated.
- The gear is shifted out of P (Park).
- The driving speed exceeds 2 mph (3 km/h).
- The driver's door is closed.

NOTICE

Easy Access Function

When exiting the vehicle the driver’s seat will move rearward when the engine is turned off and the shift lever in P (Park).

When entering the vehicle the driver’s seat will move forward when the ignition switch is placed to the ACC position.

You can activate or deactivate the Easy Access Function from the User Settings Mode on the LCD display.

For more details, refer to the "LCD Display" section in this chapter.

Recalling Positions from Memory
1. Check that the shift lever is in P (Park) while the ignition switch is in the ON position. 2. Press the desired memory button (1 or 2). The system will beep once, and then the driver’s seat ...

Steering Wheel
Electric Power Steering (EPS) The system assists you with steering the vehicle. If the engine is turned off or if the power steering system becomes inoperative, you may still steer the vehicle, b ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose & nolzzle4. Washer motor & linkage assembly5. Washer motor6. Washer reservoir7. Wiper/Washer relay (Built - in PCB block)8. Washer fluid level sensor ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Wheel Speed Sensor Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub . Tightening torque: 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to dam ...

© 2018-2024 www.helantraad.com