Hyundai Elantra: Horn / Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Horn / Repair procedures

Removal

1.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

2.	Remove the high pitch horn and low pitch horn after disconnect the horn connector (A) and loosening the mounting the bolt. [Low Pitch Horn] [High Pitch Horn]

Installation

1.	Install the horns after connect the horn connectors.

2.	Install the front bumper cover.

Inspection

1.	In this vehicle, the horn relay is mounted in the PCB block of the engine compartment relay block.

•	The semiconductor relay inserted in the PCB cannot be replaced.

•	If you need to replace the relay, replace the PCB block and perform the test.

Components and Components Location

Component Location 1. Horn switch2. Horn relay (Built - in PCB Block)3. Horn (Low pitch)4. Horn (High pitch)5. Clock spring ...

Audio

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rear Body Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer panel rear cornerSide outer panel rear cornerSide outer panel rear cornerRear combination lamp mounting hole (O8)Rear bumper mounting hole (8.5X8.5)Rear bumper mounting hole (14X16 ...

Hyundai Elantra AD (2016-2020) Owners Manual: FCA Sensor (Front Radar/Front Camera)
■ Front radar ■ Front camera In order for the FCA system to operate properly, always make sure the sensor cover or sensor is clean and free of dirt, snow, and debris. Dirt, snow, or foreign substances on the sensor cover or sensor may adversely affect the sensing performance of the se ...