Hyundai Elantra: Fender / Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement

•	When removing the fender, wrap protective tape around a screwdriver or remover not to damage components

•	Put on gloves to prevent hand injuries

•	When removing the clips, use a clip remover.

1.	Remove the front bumper. (Refer to Front Bumper - "Front Bumper Cover")

2.	Remove the head lamps. (Refer to Body Electrical System - "Head Lamps")

3.	Loosen the front wheel guard mounting screws and pin-type retainers.

4.	Using a screwdriver or remover, remove the delta garnish (A).

5.	Remove the front bumper side mounthing bracket (A) after loosening the bolts.

6.	Loosen the mounting clips and remove the insulator cover (A).

7.	After loosening the mounting bolts, remove the fender assembly (A).

To intall, reverse the removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Components and Components Location

Component Location 1. Fender assembly ...

Hood

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Muffler Repair procedures
Removal and Installation Front Muffler 1. Disconnect the battery negative terminal. 2. Disconnect the oxygen sensor connector (A). 3. Detach the rubber hanger (A) from the front muffler. 4. Remove the front muffler (B). Tightening torque : 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ...

Hyundai Elantra AD (2016-2020) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ON3.9 ~ 4.1Idle0.8 ~ 1.6 Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...