Hyundai Elantra: Body Side Molding / Rear Wheel Guard Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
After loosening the mounting screws, clips and nut, remove the rear wheel guard (A).

3.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Front Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Front Mud Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Line Pressure Control Solenoid Valve Specifications
Specifications ? Control type : Normally high type ShapeItems Specifications Control current(voltage) [mA] 0 ~ 850 Supply pressure [kpa (kgf/cm?, psi)] 539.36 (5.5, 78.23) Control pressure [kpa (kgf/cm?, psi)] 0 ~ 519.75 (0 ~ 5.3, 0 ~ 75.38)  Internal resistance( ...

Hyundai Elantra AD (2016-2020) Service Manual: Roof Trim Assembly Components and Components Location
Component Location 1. Roof Trim Assembly ...

© 2018-2023 www.helantraad.com