Hyundai Elantra: Body Side Molding / Front Wheel Guard Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Body Side Molding / Front Wheel Guard Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Remove the engine room cover. (Refer to Engine Mechanical System - " Engine Room Cover")

2.	Remove the front tire.

3.	After loosening the mounting clips and remove the front wheel guard (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Delta Garnish Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Wheel Guard Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Detecting sensor
The rear radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the system. NOTICE The system may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired. ...

Hyundai Elantra AD (2016-2020) Owners Manual: Operating Door Locks from Inside the Vehicle
With the door lock button To unlock a door, pull the door lock button (1) to the "Unlock" position. The red mark (2) on the door lock button will be visible. To lock a door, push the door lock button (1) to the "Lock" position. If the door is locked properly, the re ...