Hyundai Elantra: Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Replacement
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Cushion Assembly")
2.
Loosen the mounting bolt, remove the rear seat belt buckle (A).
[LH]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[RH]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
To intall, reverse the removal procedure.
   
The buckle and tongue of different types are impossible to be latched, so check that the buckle & tongue have the same types.
Distinguish the rear side seat buckle from the center seat buckle before latching.
If foreign materials are stuck in the inside button of buckle, it may cause interference during the latching process, leading to a functional problem (for example- beverages (viscous drinks), toothpicks, sand, plastic, vinyl, metal pieces, etc.).
After latching the buckle and tongue, check the fastening force using a Push-Pull Gauge (fastening force: 3kgf or less).
Rear Seat Belt Buckle Components and Components Location
Component Location 1. Rear seat belt buckle [RH]2. Rear center seat belt buckle [LH] ...

Body Electrical System
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Sunroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim") 3. Disconnect the sunroof motor (A) connector. 4. Ground the terminals as below table, and check that the sunroof unit operates.     • When ins ...

Hyundai Elantra AD (2016-2020) Service Manual: Variable Charge Motion Actuator (VCMA) Description and Operation
Description The Variable Charge Motion Actuator (VCMA) is installed on the inlet of the intake manifold. It consists of a DC motor which actuates the VCM valve and a position sensor which detects the position of the VCM valve. The VCM system tumbles air flow entering into combustion chambe ...

© 2018-2025 www.helantraad.com