Hyundai Elantra: Cylinder Block / Rear Oil Seal Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal

1.	Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")

2.	Remove the drive plate. (Refer to Cylinder Block – “Drive Plate”)

3.	Remove the rear oil seal (A).

Installation

Install a new rear oil seal.

(1)	Apply engine oil on the edge of new oil seal.

(2)	Using SST (09231-H1100, 09214-2E000) and a hammer, tap in the oil seal (A) until the SST face is aligned with the cylinder block assembly rear face.

2.	Install the other parts reverse order of removal.

Rear Oil Seal Components and Components Location

Components 1. Rear oil seal ...

Piston and Connecting Rod Components and Components Location

Components 1. Piston ring2. Snap ring3. Piston pin4. Piston5. Connecting rod 6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace a water pump. • If leakage stops, reuse the water pump (Do not repl ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor connector ...