Hyundai Elantra: Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Description and Operation
| Description |
| • |
Line pressure control solenoid valve is attached to the valve body. |
| • |
This variable force solenoid valve indirectly controls the hydraulic pressure inside the line pressure.
|
26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
M ...
Line Pressure Control Solenoid Valve Specifications
Specifications
? Control type : Normally high type
ShapeItems Specifications Control current(voltage) [mA] 0 ~ 850 Supply pressure [kpa (kgf/cm?, psi)] 539.36 (5.5, 78.23) C ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Relay Box (Engine Compartment) Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Pull out the relay from the engine compartment relay block.
Power Relay (Type A)
Check for continuity between the terminals.
1.
After supplying power to between No. 85 and 86 power relay
terminals, check that there is co ...
Hyundai Elantra AD (2016-2020) Service Manual: TPMS Receiver Description and Operation
Description
TPMS Receiver : BCM(body control module) integrated management
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Location, no sensor wake-up, no sens ...
