Hyundai Elantra: Rear Door / Rear Door Window Glass Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Window Glass Repair procedures

Replacement

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the rear door belt inside weatherstrip (A).

3.	Pull down rear door window glass by pressing the power window glass switch.

4.	Loosen the mounting screws and remove the rear door belt outside weatherstrip (A).

5.	Completely loosen the rear door channel mounting bolts and unscrew the loosely as possible without removing them from the rear door panel.

Slightly push the rear door channel in the direction of arrow as below.

Tightening torque :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Remove the rear door window glass mounting hole plug (A).

•	Be careful not to drop the glass and/or scratch the glass surface.

•	Use the door switch to align the mounting hole/bolt with the hole in the door.

•	If unable to operate the window motor, remove the motor and align the hole by hand.

Carefully adjust the rear door window glass (A) until the bolts are visible, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :

8.8 ~ 11.8 N.m (0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 lb-ft)

To intall, reverse the removal procedure.

•	Make sure that the glass rolls up and down smoothly.

•	Adjust glass position as needed.

•	Make sure the door locks and opens properly.

•	Replace any damaged clips (or pin-type retainers).

Rear Door Window Glass Components and Components Location

Component Location 1. Rear door window glass ...

Rear Door Module Components and Components Location

Component Location 1. Rear door module ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: DCT warning messages
Steep grade This warning message is displayed when vehicle is driven slowly on a grade and the vehicle detects that the brake pedal is not applied. Driving up hills or on steep grades: To hold the vehicle on an incline use the foot brake or the parking brake. When in stop-and-go traffic ...

Hyundai Elantra AD (2016-2020) Service Manual: Crankcase Emission Control System
Schematic Diagrams Schematic Diagram Repair procedures Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV valve and make ...