Hyundai Elantra: Seat Electrical / Power Seat Motor Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Repair procedures

Inspection

Diagnosis with GDS

The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).

The diagnostic system (GDS) provides the following information.

(1)	Self diagnosis : Checking the failure code (DTC) and display

(2)	Current data : Checking the system input/output data state

(3)	Actuator test : Checking the system operation condition

(4)	Additional function : Other controlling such as he system option and zero point adjustment

2.	Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.

3.	Select the "Power Seat Module (PSM)" to check the power seat module (PSM).

4.	Select the "Current Data" menu to search the current state of the input/output data. The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.

5.	If you will check the power door lock operation forcefully, select "Actuation test".

Power Seat Motor

1.	Disconnect the connectors for each motor. [Slide Motor] [Rear Height Motor] [Front Height Motor] [Reclining Motor] [Lumbar Support Motor]

2.	With the battery connected directly to the motor terminals, check if the motors run smoothly.

3.	Reverse the connections and check that the motor turns in reverse.

4.	If there is an abnormality, replace the motors. [Driver / Assist]

[Reclining Motor Limit Switch]

•	The power seat motor(IMS specification) mounted in this vehicle uses the hole sensor to calculate the maximum operation distance, so it does not require limit switch.

•	But, NON- IMS specification driver seat and passenger seat have limit switches in the motor in the back of the chairs.

1.	Disconnect the limit switch and operate the limit switch.

2.	Check for continuity between the terminals.

3.	Make sure that the seat operation is normal in the reverse after the maximum operation.

4.	If there is an abnormality, replace the limit switch.

Remove

Front Seat

1.	Disconnect the battery terminals.

2.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

Power Seat Motor Components and Components Location

Component Location 1. Lumber support motor (Horizontal)2. Rear height motor3. Reclining motor4. Slide motor5. Front height motor6. Reclining limit switch7. Lumber support switch8. Seat switch ...

Power Seat Control Switch Schematic Diagrams

Circuit Diagram ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Under Body Body Repair
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O ...

Hyundai Elantra AD (2016-2020) Owners Manual: FCA Sensor (Front Radar/Front Camera)
■ Front radar ■ Front camera In order for the FCA system to operate properly, always make sure the sensor cover or sensor is clean and free of dirt, snow, and debris. Dirt, snow, or foreign substances on the sensor cover or sensor may adversely affect the sensing performance of the se ...