Hyundai Elantra: Rear Door / Rear Door Outside Handle Repair procedures

Replacement
1.
Remove the plug hole (B).
2.
After loosening the mounting bolt, remove the front door lock (A).

Tightening torque :
7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

3.
Remove the rear door outside handle (A) by pushing it in the direction of arrow.

4.
To intall, reverse the removal procedure.
   
•
Make sure the door locks / unlocks and opens / closes properly.
•
Be sure to install the outside handle pad (A) between the outside handle and the door panel.

Rear Door Outside Handle Components and Components Location
Component Location 1. Rear door outside handle ...

Rear Door Latch Components and Components Location
Component Location 1. Rear door latch ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw. Installation 1 ...

Hyundai Elantra AD (2016-2020) Service Manual: Knock Sensor (KS) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") 4. Remove the installation bolt (A), and then remove the sens ...

© 2018-2026 www.helantraad.com