Hyundai Elantra: Rear Door / Rear Door Module Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Repair procedures

Replacement

1.	Remove the rear door window glass. (Refer to Rear Door - "Rear Door Window Glass")

2.	Remove the rear door outside handle. (Refer to Rear Door - "Rear Door Outside Handle")

Loosen the rear door latch mounting screws.

Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.0 ~ 8.0 lb-ft)

After loosening the mounting bolts, remove the rear door module (A).

Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.	Remove the rear door latch assembly. (Refer to Front Door - "rear Door Latch")

6.	Reomove the rear speaker . (Refer to Body Electrical System - "Speakers")

7.	Remove the rear power window motor. (Refer to Body Electrical System - "Power Window Motor")

To intall, reverse the removal procedure.

•	Make sure connectors are connected properly and each rod is connected securely.

•	Make sure the door locks / unlocks and opens / closes properly.

Rear Door Module Components and Components Location

Component Location 1. Rear door module ...

Rear Door Outside Handle Components and Components Location

Component Location 1. Rear door outside handle ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Windshield Glass
Components and Components Location Components 1. Windshield glass Repair procedures Replacement [Removal] • Put on gloves to prevent hand injuries. • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side m ...

Hyundai Elantra AD (2016-2020) Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification : Refer to "Specification" Removal 1. Turn the ignition switch O ...