Hyundai Elantra: Rear Door / Rear Door Latch Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch Repair procedures

Replacement

1.	Remove the rear door module. (Refer to Rear Door - "Rear Door Module")

2.	Remove the rear door inside handle cage (A).

3.	Disconnect the rear door latch connector (A).

4.	Loosen the mounting bolt and remove the rear door latch (A).

5.	Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.

6.	Remove the rear door outside handle cable (A).

To intall, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin-type retainers).

Rear Door Latch Components and Components Location

Component Location 1. Rear door latch ...

Rear Door Belt Outside Weatherstrip Repair procedures

Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the rear door belt outside wea ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Sunroof
Components and Components Location Components 1. Glass panel assembly2. Deflector3. Motor assembly4. Spring base assembly5. Plate rail assembly6. Guide rail assembly7. Drip link rail8. Seal tape9. Frame sub assembly10. Stopper11. Sunshade assembly12. Drip rail assembly Repair procedures Adju ...

Hyundai Elantra AD (2016-2020) Service Manual: Fender
Components and Components Location Component Location 1. Fender assembly Repair procedures Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries ...