Hyundai Elantra: Rear Door / Rear Door Belt Inside Weatherstrip Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Inside Weatherstrip Repair procedures

Replacement

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the rear door belt inside weatherstrip (A).

To intall, reverse the removal procedure.

•	When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame.

•	Replace any damaged clips.

Rear Door Belt Outside Weatherstrip Repair procedures

Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the rear door belt outside wea ...

Rear Door Side Weatherstrip Repair procedures

Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m,12.3 ~ 15.9 lb-ft) 2. Detach the clips, remove the rear door side weat ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Sensor to Detect Distance to the Vehicle Ahead
The Smart Cruise Control uses a sensor to detect distance to the vehicle ahead. If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle distance control may not operate correctly. Always keep the sensor clean. Warning message Smart Cruise Control disabled. Radar ...

Hyundai Elantra AD (2016-2020) Service Manual: Smart Cruise Control Switch Repair procedures
Inspection [Measuring Resistance] 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed). Function switchTerminalResistanceSET -2 - 5550?±5%RES +2 - ...