Hyundai Elantra: Rear Seat / Rear Back Armrest Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Repair procedures

Replacement

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Fold the rear seat back assembly [LH] (A) by pulling the folding lever in the direction of the arrow.

2.	Separate the rear back armrest (A) after removing the cap and then loosening the bolt.

3.	To install, reverse the removal procedure.

Rear Seat Cushion Cover Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Seat Folding Lever Components and Components Location

Components 1. Rear seat folding lever ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: TJ Joint Components and Components Location
Components [RH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ case13. Clip [LH] 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Shaft6. TJ boot band7. TJ ...

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation
Description • 35R Clutch control solenoid valve(35R/C) is attached to the valve body. • This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...