Hyundai Elantra: Parking Brake System / Parking Brake Lever Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery cable. |
| 2. |
Release the parking brake. |
| 3. |
Remove the floor console assembly.
(Refer to Body - "Floor console") |
| 4. |
Disconnect the connector (A) of parking brake switch.
|
| 5. |
Remove the parking brake cable after removing the nut and cable retainer.
|
| 6. |
Remove the parking brake lever assembly (A) after loosening the bolts.
|
| Installation |
| 1. |
Install the parking brake lever assembly (A).
|
| 2. |
Install the parking brake cable after removing the cable retainer.
|
| 3. |
Apply a coating of the specified grease to each sliding parts (A) of the ratchet plate or the ratchet pawl.
|
| 4. |
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
|
| Adjustment |
| 1. |
Remove the floor console assembly.
(Refer to Body - "Floor console") |
| 2. |
Bring the brake pads in their operating position by pressing the brake pedal down several times until there is resistance. |
| 3. |
Tension the parking brake cable by tightening the adjusting
nut, until the operating levers on both calipers lift from the stop, up
to a distance of (A) and (D) between operating lever (B) and stopper
(C).
|
| 4. |
adjust the parking brake lever stroke by turning adjusting nut (A).
|
| 5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if
necessary. |
| 6. |
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully. |
| 7. |
Install the floor console.
(Refer to Body - "Floor Console") |
Components and Components Location
Components
[Disc type]
1. Parking brake lever2. Equalizer assembly3. Parking brake cable4. Brake disc5. Brake caliper
[Drum type]
1. Parking brake lever2. Equalizer assembly3. Parking ...
Parking Brake Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor console")
4.
Disconnect the connect ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Automatic Heating and Air Conditioning
The Automatic Climate Control System is controlled by setting the desired temperature.
1. Press the AUTO button.
The modes, fan speeds, air intake and air-conditioning will be controlled automatically
by the temperature setting you select.
2. Turn the temperature control knob to the desired ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub .
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
•
Be careful not to dama ...
