Hyundai Elantra: Parking Brake System / Parking Brake Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery cable. |
| 2. |
Release the parking brake. |
| 3. |
Remove the floor console assembly.
(Refer to Body - "Floor console") |
| 4. |
Disconnect the connector (A) of parking brake switch.
|
| 5. |
Loosen the screw and then remove the parking brake switch.
|
| 6. |
To install, reverse the removal procedure. |
Parking Brake Lever Repair procedures
Removal
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor console")
4.
Disconnect the connect ...
Parking Brake Cable Repair procedures
Removal
[Rear disc brake type]
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor console")
4. ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the mode control actuator operates to the vent mod ...
Hyundai Elantra AD (2016-2020) Service Manual: SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...
