Hyundai Elantra: Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Emission Control System / Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Repair procedures

Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
3.
Remove the ORVR (A) after releasing hooks (B).

Installation
1.
Installation is the reverse of removal.
Canister Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Disconnect the ventilation hose (A), and canister close valve extension co ...

Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and t ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: System Operation
Ventilation 1. Select the Face Level mode. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desired speed. Heating 1. Select the Floor Level mode. 2. Set the air intake control to t ...

Hyundai Elantra AD (2016-2020) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification : Refer to "Wave Form" Removal     • DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine ...

© 2018-2026 www.helantraad.com