Hyundai Elantra: Evaporative Emission Control System / Canister Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Lift the vehicle. |
| 3. |
Disconnect the ventilation hose (A), and canister close valve extension connector (B).
|
| 4. |
Disconnect the vapor tube quick-connector (A). |
| 5. |
Remove installation nuts & bolt (B) and then remove the canister assembly.
|
| 6. |
Remove the installation bolt (A), and then remove the air filter (B).
|
| Inspection |
| 1. |
Check for the following items visually.
A: Canister - Atmosphere
B: Canister - Intake Manifold
C: Canister - Fuel Tank
|
| Installation |
| 1. |
Installation is the reverse of removal.
|
Repair procedures
Inspection
[EVAP. Leakage Test]
1.
Select "Evap. Leakage Test".
2.
Proceed with the test according to the screen introductions.
[PCSV Inspection]
1.
Turn ignition switch OFF and dis ...
On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
3.
Remove the ORVR (A) after releasing hooks (B) ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Belt Inside Weatherstrip Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
3.
To intall, reverse the removal procedure.
•
When installing, install it by first contacting the inside part (basis point ...
Hyundai Elantra AD (2016-2020) Service Manual: Front Wheel Speed Sensor Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
•
Be careful not to dam ...
