Hyundai Elantra: Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the MAPS at idle and IG ON.

Condition	Output Voltage (V)
IG ON	3.9 ~ 4.1
Idle	0.8 ~ 1.6

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

Installation is reverse of removal.

Manifold absolute pressure sensor installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams

Circuit Diagram ...

Intake Air Temperature Sensor (IATS) Description and Operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Troubleshooting • The battery must be in good condition and fully charged for this troubleshooting. ...

Hyundai Elantra AD (2016-2020) Owners Manual: Engine Start/Stop Button. Starting the engine
Whenever the front door is opened, the Engine Start/Stop button will illuminate and will go off 30 seconds after the door is closed. WARNING To reduce risk of serious injury or death, NEVER allow children or any person who is unfamiliar with the vehicle to touch the Engine Start/Stop button ...