Hyundai Elantra: Automatic Transaxle Control System / Inhibitor Switch Description and Operation
| Description |
| • |
The inhibitor switch mounted on the upper of transaxle and connected with shifter lever. |
| • |
The inhibitor switch has four points of contact and it makes the signals(S1, S2, S3, S4). |
| • |
The inhibitor switch signals delivered at the TCM according
to control of the shift lever positions(P, R, N, D) and it is used to
control of the gear setting.
|
SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
...
Inhibitor Switch Specifications
Specifications
? Type: Combination of output signals from 4 terminals
? Specifications
Items Specifications Power supply (V)12Output type Combination of output signals
...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Auto Defogging Sensor Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling ...
Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description
Body Control Module (BCM) function
NoItemDescription1Washer Linked Wiper
-
If the washer switch is pressed ON for 0.06~0.2 second with
the vehicle mode in IGN2, the wiper relay is turned ON 0.3±0.1 second
after washer switch ON, and then the wiper relay is turned OFF 0.7Â ...
