Hyundai Elantra: Body Electrical System / Immobilizer System

Blind Spot Detection Indicator Repair procedures
Removal Blind Spot Detection Warnig Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warnig Indicator 1. Install th ...

Schematic Diagrams
Circuit Diaram ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Control Module (ECM) Repair procedures
Removal     • When replacing the ECM, the vehicle equipped withthe immobilizer must be performed procedure asbelow. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with GDS. (Refer to Body Electrical System - "Immobilizer System") 2) After ...

Hyundai Elantra AD (2016-2020) Service Manual: Lumber Support Units Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly") 3. Remove the seat back. (Refer to Body - "Front Seat Back Cover") 4. Disconnect the lumber support motor connector (A). 5. Separate the retaining ...

© 2018-2026 www.helantraad.com