Hyundai Elantra: Immobilizer System / Immobilizer Control Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Discnnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.

Installation
1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the main crash pad assembly.
3.
Connect the negative (-) battery terminal.
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a ...

Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel") 3. Disconnect the 6P connector (B) of ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Power Seat Control Switch Repair procedures
Inspection Seat Control Switch 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. [Power Seat Control Switch] Removal 1. Disconnect the negative (-) battery ter ...

Hyundai Elantra AD (2016-2020) Service Manual: Rear Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor cable ...

В© 2018-2026 www.helantraad.com