Hyundai Elantra: Blind Spot Detection System / Blind Spot Detection Indicator Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Indicator Repair procedures

Removal

Blind Spot Detection Warnig Indicator

1.	Disconnect the negative (-) battery terminal.

2.	Remove the mirror (A).

Installation

Blind Spot Detection Warnig Indicator

1.	Install the outside mirror.

2.	Connect the negative (-) battery terminal.

Inspection

1.	Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.

Blind Spot Detection Indicator Components and Components Location

Components 1. BSD Indicator2. Side repeater lamp ...

Immobilizer System

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Lower Arm Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • Be careful not to dam ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Wiper Motor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm. 3. Remove the cowl top cover. (Refer to Body - "Cowl Top Cover") 4. Disconnect the windshield d ...