Hyundai Elantra: Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Replacement

•	When installing the belt, make sure not to damage the pretensioner.

1.	Remove the center pillar upper trim. (Refer to Interior Trim - "Center Pillar Trim")

After loosening the front belt upper anchor mounting bolt, remove the front belt upper anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.	Disconnect the connector (A)

Loosen the mounting bolt and removing the front safety belt retractor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

To intall, reverse the removal procedure.

•	After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Front Seat Belt Pretensioner Components and Components Location

Component Location 1. Front seat belt pretensioner ...

Height Adjust Components and Components Location

Component Location 1. Height adjust ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Output Speed Sensor Specifications
Specifications ? Type: Hall effect sensor ? Specifications ItemsSpecificationsOperation condition [°C(°F)](-40 ~ 150) -40 ~ 302Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Hyundai Elantra AD (2016-2020) Owners Manual: Checking the Engine Coolant Level
■ 1.6 T-GDI ■ 2.0 MPI Check the condition and connections of all cooling system hoses and heater hoses. Replace any swollen or deteriorated hoses. The coolant level should be filled between the F and the L marks on the side of the coolant reservoir when the engine is cool. If the coo ...