Hyundai Elantra: Exterior Features / Fuel Filler Door

Opening the fuel filler door

Hyundai Elantra. Fuel Filler Door

The fuel filler door must be opened from inside the vehicle by pulling up the fuel filler door release lever.

1. Turn the engine off. Locate the fuel filler door release lever on the floor on the left side of the driver seat.

2. Pull up on the release lever.

Hyundai Elantra. Fuel Filler Door

3. Pull the fuel filler door (1) out to fully open.

4. To remove the fuel tank cap (2), turn it counterclockwise. You may hear a hissing noise as the pressure inside the tank equalizes.

5. Place the cap on the fuel filler door.

Information

If the fuel filler door does not open because ice has formed around it, tap lightly or push on the door to break the ice and release the door. Do not pry on the door. If necessary, spray around the door with an approved deicer fluid (do not use radiator antifreeze) or move the vehicle to a warm place and allow the ice to melt.

Closing the fuel filler door

1. To install the fuel tank cap, turn it clockwise until it "clicks" one time.

2. Close the fuel filler door until it is latched securely.

Information

WARNING

Gasoline is highly flammable and explosive. Failure to follow these guidelines may result in SERIOUS INJURY or DEATH:

Information

Make sure to refuel your vehicle according to the "Fuel Requirements" suggested in the Introduction chapter.

NOTICE

How to deactivate the Smart Trunk function using the smart key
1. Door lock 2. Door unlock 3. Trunk open 4. Panic If you press any button of the smart key during the Detect and Alert stage, the Smart Trunk function will be deactivated. Make sure to be awa ...

Instrument Cluster
â–  Conventional cluster â–  Supervision cluster (Type A) 1. Tachometer 2. Speedometer 3. Engine coolant temperature gauge 4. Fuel gauge 5.Warning and indicator lights 6. LCD display (inclu ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: TPMS Sensor Description and Operation
Description 1. General description WU is a sensor placed in the tire that reports pressure and temperature. The WU is mounted inside the wheels, fixed to the valve. The angle between the valve and the housing of the WU is variable. This allows adaptation to various types of rims. The Wheel ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Seat Frame Assembly Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Use a plastic panel removal tool to remove int ...

© 2018-2026 www.helantraad.com