Hyundai Elantra: Front Door / Front Door Belt Inside Weatherstrip Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Inside Weatherstrip Repair procedures

Replacement

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

2.	Remove the front door belt inside weatherstrip (A).

To intall, reverse the removal procedure.

•	When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame.

•	Replace any damaged clips (or pin-type retainers).

Front Door Belt Outside Weatherstrip Repair procedures

Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside w ...

Front Door Side Weatherstrip Repair procedures

Replacement [Front door side weatherstrip] 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 18.6 ~ 28.4 N.m (1.7 ~ 2.2 kgf.m,13.7 ~ 21.0 lb-ft) 2. Detach the cl ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Blind Spot Detection Indicator Components and Components Location
Components 1. BSD Indicator2. Side repeater lamp ...

Hyundai Elantra AD (2016-2020) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ON3.9 ~ 4.1Idle0.8 ~ 1.6 Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...