Hyundai Elantra: Braking System / Disc Brakes Wear Indicator, Rear Drum Brakes

Hyundai Elantra AD (2016-2020) Owners Manual / Driving Your Vehicle / Braking System / Disc Brakes Wear Indicator, Rear Drum Brakes

Disc Brakes Wear Indicator

When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you depress the brake pedal.

Note that some driving conditions or climates may cause a brake squeal when you first apply (or lightly apply) the brakes. This is normal and does not indicate a problem with your brakes.

NOTICE

To avoid costly brake repairs, do not continue to drive with worn brake pads.

Information

Always replace brake pads as complete front or rear axle sets.

Rear Drum Brakes

Your rear drum brakes do not have wear indicators. Therefore, have the rear brake linings inspected if you hear a rear brake rubbing noise. Also have your rear brakes inspected each time you change or rotate your tires and when you have the front brakes replaced.

Power Brakes
Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes will not work. ...

Parking Brake
Always set the parking brake before leaving the vehicle. To apply the parking brake: Firmly depress the brake pedal. Pull up the parking brake lever as far as possible. WARNING To reduce the r ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Brake Booster Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster ...

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Sensor Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the fuel sender connector (A). 3. Remove the fuel sender (A) in the direction of an arrow. Installation 1. Installation is reverse of removal. ...

В© 2018-2026 www.helantraad.com