Hyundai Elantra: Floor Console / Console Armrest Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Remove the rear console cover.
(Refer to Floor Console - "Rear Console Cover")
3.
Loosen the mounting screws and remove the console armrest (A).

4.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Console Armrest Components and Components Location
Component Location 1. Console armrest ...

Crash Pad
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components 1.  Piston ring2.  Snap ring3.  Piston pin4.  Piston5.  Connecting rod 6.  Connecting rod upper bearing7.  Connecting rod lower bearing8.  Connecting rod bearing cap9. Cylinder block10. Crankshaft upper bearing11. Crankshaft thrust bearing12. C ...

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Troubleshooting Trouble SymptomCause of the symptomRemedyExcessive play in steeringLoose U-joint boltRetighten or replace as necessaryLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessarySteering wheel does not return to i ...

© 2018-2025 www.helantraad.com